Common Plumbing Concerns and How to Deal With Them

Regardless of how well designed your plumbing system at home may be, it is still possible for certain plumbing problems to arise. Sometimes no matter how well you take care of the pipes, they still begin to leak eventually. The faucets and shower also start to act up while the toilet and tub start to get clogged. There are many reasons why these things happen, but most of the time these occur when the water pressure is too high, the temperature suddenly drops down, or the fixtures are simply old. Whatever the reason is, you can’t deny the fact that these all cause inconvenience.

Therefore, it’s important that you are always prepared and know how to perform basic repairs so that you can alleviate the problem while waiting for the plumbing contractor in Sherwood Park.

Runny Toilet — This type of problem is usually caused by a misaligned float but if you know how to adjust the toilet float, you can practically take care of the problem before it gets worse. Every time you flush the toilet, the float drops, causing the valve to open and allowing the tank to be refilled. When the water reaches a certain level, the float is supposed to rise, causing the valve to close and water to stop entering the tank. However, since the float is misaligned, the valve is left open and water continues to enter the tank causing water to overflow. To fix this, simply bend the arm that holds the float to the right angle so that the float closes the valve before the tank gets full.

Plumbing

Clogged Bathtub Drain — First, determine the cause of the problem. Most of the time, the clogging is due to the accumulation of hair and other sediments on the drain. You can check the strainer, use a plunger, or pour some cleaner down the drain. However, if none of these work for you, you need to call a plumber. He’ll use a special tool, the plumber’s snake, to pull the clog out.

Leaking Bathtub Trap — If you know how to unclog a bathtub, then fixing a leaking trap should not be a big deal at all. The bathtub trap serves as a water stopper, and overtime it can rust and eventually break causing water to leak. To repair the trap, you will need to clean it from rust and other elements that may be causing the clog. The trap is located below the tub faucet. Remove the trap and clean the area surrounding it. Take out a new drain trap and replace the old one, applying putty around it and tightening it in place. Once the new trap is in place, check for leaks by running water into the tub.

The problems discussed above are easy to deal with if you have the tools and skills needed. Otherwise, do not think twice in calling a professional plumber.